Inspect The Charger Of Autel Maxivideo MV400

Before you use the Autel Maxivideo MV400,you need to inspect the charger and charge the battery so you can avoid the risk of injury from electric shock,fire and other causes.

Here we will share the information about inspecting the charger.Before you inspect the charger,you need to check the charger and be sure it is unplugged. Then you should inspect the power cord and the charger and make sure they are in good conditions and hadn't been damaged, modified, broken, worn or missed.If there has any problem,you can not use the charger until the problems have been repaired or you have replace the bad part.

Then you need to clean the tool,especially its' buttons and make sure there has no oil,grease or dirt.This step is done for avoiding the tool would slip from your hands.And besides,you need to check the warning label on charger's surface and be sure that it is intact and readable.

Next you need to check the work area for using the Autel Maxivideo MV400 better.Please remember that the charger should only work in the temperature between 41°F (5°C) and 113°F (45°C).Once the temperature is beyond the range when you are using it to charge,the operation would be suspended until it is in the correct temperature range.And the charger need a clearance of at least 10cm on all sides to make sure a right operating temperature.

For more OBD2 Code Scanner or other OBD2 tools, please visit our home site: http://www.obd2life.com